Chrysler 200
Front Side Marker Light Bulb Replacement Guide
How to change a burnt out side marker
light bulb in the front quarter panel of a 2015, 2016 and 2017 Chrysler 200.
2015 Chrysler 200 |
Front Side Marker Light |
Remove Top Screw |
This
automotive maintenance tutorial was specifically written to assist
owners of the second generation 2015, 2016 and 2017 Chrysler 200
sedan in changing a burnt out front side marker light bulb located
in the front bumper cover. Owners of other Chrysler, Dodge, Jeep, RAM or Fiat vehicles such as the 300, Pacifica, Town & Country, Avenger, Charger, Challenger, Journey, Dart, Durango, Magnum, Grand Caravan, Fiat 500, Fiat 124 Spider, Grand Cherokee, Renegade, Wrangler, Compass, Liberty, Patriot, ProMaster, 1500 and C/V Tradesman minivan may also find these DIY instructions to be helpful. A compatible replacement miniature wedge base light bulb is part number 2821 (or W3W). You can also use a brighter LED unit. The tools needed to access and replace the side marker light bulb include an 8mm socket and a 1/4" drive ratchet. |
||
|
||
Remove 3rd Lower Screw |
Three Screws Removed |
Pull Back Wheel Well Liner |
Locate the three
screws along the front edge of the black plastic wheel well liner near the
side marker bulb housing. Remove the three screws by turning them counterclockwise with an 8mm socket and a 1/4" drive ratchet. Set the three screws aside in a safe place. Gently pull back the black plastic wheel well liner to access the rear of the light housing. |
||
1/4 Turn Counterclockwise |
Bulb Socket Removed |
Old Light Bulb Removed |
Rotate the black
and white plastic bulb socket 1/4 turn counterclockwise before pulling it
straight out of the housing. Pull the old light bulb straight out of the socket. |
||
|
||
Push In New Light Bulb |
1/4 Turn Clockwise - Lock |
Replace Wheel Well Liner |
Push a new number 2821 (also known as the # W3W) light bulb straight in to the socket. If you would like to have brighter side marker lights, install a compatible 2821 LED bulb. Re-insert the bulb socket in to the housing and rotate it 1/4 turn clockwise to secure it in place. Push the black plastic wheel well liner (or "splash guard") back into place. |
||
Spin In 3 Screws |
Tighten Clockwise |
Side Marker Bulb Replaced |
Replace the three
8mm screws and tighten them in the clockwise direction until they are snug. To test the new side marker light bulbs, turn on the headlights or press the "Unlock" button on the key fob to activate the exterior lights. For more, please check out all of my
2015-2017 Chrysler 200 DIY Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info