Nissan Armada
Door Step Courtesy Light Bulb Replacement Guide
How to change a burnt out step courtesy
bulb in the passenger door panels of a 2004 to 2015 Nissan Armada SUV.
Armada Courtesy Step Light |
Insert Screwdriver |
Pry Out Light Housing |
This
automotive "how-to" guide was specifically written to assist owners
of the 1st generation (2004, 2005, 2006, 2007, 2008, 2009, 2010,
2011, 2012, 2013, 2014 & 2015) Nissan Armada in changing a burnt out
step courtesy light bulb at the bottom of the passenger door panels. Owners of other Nissan or Infiniti vehicles such as the Versa, Cube, Sentra, Altima, LEAF, Maxima, 370Z, Juke, Rogue, Murano, Xterra, Pathfinder, Quest, Frontier, Titan, QX56, Q50, G37, EX37, QX60, FX37, FX50 and QX80 may also find these DIY instructions to be helpful. A replacement step courtesy light bulb is part number 194 from manufacturers such as Sylvania, GE, Eiko and PIAA. You may also choose to use any other miniature wedge base bulb such as the W5W, 168, 2825 or a brighter LED unit. The only tool needed to replace the step courtesy bulb is a small flathead screwdriver used to pry out the light housing. |
||
|
||
Disconnect Power Plug |
Push Out Old Light Bulb |
Old # 194 Bulb |
You may choose to cover the tip of the flathead screwdriver with a thin micro fiber cloth to prevent from scratching the plastic surfaces. Insert the blade of the small flathead screwdriver in between the rear edge of the step courtesy light housing and the door panel. Gently pry out the housing and disconnect the power plug. Be careful when you remove the old light bulb. If it was recently turned on, it might still be hot enough to burn your fingers. Carefully push the old bulb out of the socket with the small flathead screwdriver. |
||
Push In New Bulb |
Push In Power Connector |
New Bulb Working |
Push a new # 158,
168 or
194 miniature wedge base bulb straight in to the socket. You can also use a brighter LED bulb. Slide the power connector straight in to the socket until it clicks in to place. The new bulb should illuminate immediately when you re-connect the power plug. |
||
Insert Light Housing |
Pop Housing In To Place |
Step Bulb Replaced |
Re-insert the power
wires at the front edge of the housing in first and then gently snap the
other end in to place. For more,
check out my other
Nissan
Armada Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info