Owners of other Jeep, Dodge and RAM vehicles such as the Grand Cherokee, Compass, Renegade, Gladiator, Cherokee, Grand Wagoneer, Wagoneer, Charger, Challenger, Durango, RAM 1500, Promaster, 2500 and 3500 may also find these DIY instructions to be helpful.

The OEM speakers can be replaced with aftermarket speakers in the following sizes: Tweeters 2.5", Mid-Range 3.5" and Subwoofers 4.5".

Note - The speaker sizes may vary depending on the model year or trim level of your vehicle, the optional audio package selected and your region of the world. Please measure your old speakers and consult with a car audio professional before purchasing new speakers.

The tools needed to complete this procedure include a Torx T30 star bit screwdriver and a Torx T20 screwdriver.

If you'd like to avoid rattles and vibrations when you crank up the volume, I recommend applying sound deadening material such as Dynamat or Kilmat.

The first step is to sit inside the vehicle and then locate the plastic grille (cover) for the overhead sound bar speakers attached to the roll bar.

Loosen them in the counterclockwise direction with the Torx T-30 star bit screwdriver.

When you remove the fourth bolt, hold the cover in place with one hand.

Carefully remove the speaker cover and set it aside in a safe place.

Each side of the roll bar has three speakers including a 4.5" subwoofer, a 3.5" midrange speaker and a 2.5" tweeter speaker.

(Note - Your vehicle may have different speaker sizes depending on the model year, trim level, optional audio package or your region of the world.)

For this guide, I'll be removing the 4.5" subwoofer speaker.

Remove the three black screws by turning them in the counterclockwise direction with the Torx T-20 screwdriver.

Carefully pull the subwoofer speaker out of the roll bar.

Pinch the two release tabs on the electrical connector and slide it straight out of its socket.

Replace the three screws by turning them in the clockwise direction with the Torx T-20 screwdriver until they are snug.

Try to avoid over tightening the screws to prevent from cracking the plastic speaker housing or mounting tabs.

Replace the four silver Torx T30 bolts by turning them in the clockwise direction until they are snug.

Be sure to write down any procedures that you performed in your vehicle's service records.

For more, please check out all of my 2018-2023 Jeep Wrangler DIY Maintenance Guides.